Epson Stylus Pro 3800 Service Manual page 201

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890
4.4.1.2 PULLEY, DRIVEN, ASSY.
1. Remove the HOUSING, UPPER.
2. Remove the ASF, ASSY. (p197)
3. Remove the EXTENSION SPRING 28.38 from the each hook of the main frame
and the HOLDER, PULLEY, DRIVEN.
4. Slide the HOLDER, PULLEY, DRIVEN to the right to disengage the two tabs,
and remove the HOLDER, PULLEY, DRIVEN to the front.
5. Push down the PULLEY, DRIVEN, ASSY., to release the PULLEY, DRIVEN,
ASSY. and the BELT, CR from the HOLDER, PULLEY, DRIVEN.
Be sure to install the PULLEY, DRIVEN, ASSY. to the HOLDER,
PULLEY, DRIVEN so that the protrusion on the shaft of the
PULLEY, DRIVEN, ASSY. faces downward.
DISASSEMBLY & ASSEMBLY
(p107)
Disassembly/Assembly Procedure (Group 2)
Rear side
HOLDER, PULLEY, DRIVEN
tabs
Figure 4-152. Removing the EXTENSION SPRING 28.38 and HOLDER, PULLEY, DRIVEN
Left front side
HOLDER, PULLEY, DRIVEN
protrusion
PULLEY, DRIVEN, ASSY.
Figure 4-153. Removing the PULLEY, DRIVEN, ASSY.
Revision C
EXTENSION SPRING 28.38
BELT, CR
201