Epson Stylus Pro 3800 Service Manual page 198

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890
5. Disconnect the connector from the ASF SENSOR.
6. Release the FFC and cables listed below from the cable guides on the ASF,
ASSY.See Figure 4-149.
HARNESS, ENCODER, PF
HARNESS, DETECTOR, ASF
HARNESS, DETECTOR, RELEASE
7. Remove the screw that secures the grounding wire of the MOTOR ASSY., ASF
and remove the wire. See Figure 4-150.
One C.B.P. 3 x 8 screw (6 ± 1 kgf.cm)
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 2)
Left side of the printer
HARNESS, DETECTOR, ASF
cable guides
ASF SENSOR
HARNESS, DETECTOR, RELEASE
Figure 4-149. Releasing the FFC and cables
Right side of the printer
Put the screwdriver
through this hole.
MOTOR ASSY., ASF
Figure 4-150. Removing the screws from the MOTOR ASSY., ASF
Revision C
HARNESS, ENCODER, PF
C.B.P. 3x8
grounding wire
(MOTOR ASSY., ASF)
198