Epson Stylus Pro 3800 Service Manual page 107

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890
4.3.3.12 HOUSING, UPPER
1. Remove the HOUSING, REAR, ASSY.
2. Remove the HOUSING, FRONT, LEFT.
3. Remove the HOUSING, FRONT, RIGHT.
4. Remove the COVER, PRINTER.
5. Remove the HOUSING, LEFT.
6. Remove the HOUSING, RIGHT.
7. Remove the HOUSING, FRONT, UPPER.
8. Remove the OPERATION, PANEL, ASSY.
9. Remove the four screws that secure the HOUSING, UPPER to the main unit.
Three C.B.P. 3 x 8 screws (6 ± 1 kgf.cm)
One C.B.P. 3 x 12 screw (6 ± 1 kgf.cm)
Note that the LOCK, COVER, ASSY. is attached to the HOUSING,
C A U T I O N
UPPER, and it is connected to the main unit with cables. When
removing the HOUSING, UPPER, be careful not to separate it too
much from the main unit to avoid damaging the cables.
10. Remove the HOUSING, UPPER upward.
When removing the HOUSING, UPPER, push outward on the left
C H E C K
P O I N T and right sides of the HOUSING, UPPER to widen it in order not to
hit the drive gear.
11. Remove the LOCK, COVER, ASSY. from the HOUSING, UPPER.
Be sure to insert the four positioning holes of the HOUSING,
UPPER over the guide pins on the main unit as shown in
4-19.
DISASSEMBLY & ASSEMBLY
(p96)
(p98)
(p99)
(p100)
(p103)
(p104)
(p105)
(p106)
(p125)
Disassembly/Assembly Procedure (Group 1)
positioning point
Figure
positioning point
C.B.P. 3x8 positioning point
HOUSING, UPPER
positioning point
C.B.P. 3x8
Figure 4-19. Removing the HOUSING, UPPER
Revision C
C.B.P. 3x8
C.B.P. 3x12
107