Epson Stylus Pro 3800 Service Manual page 158

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890
12. Remove the COVER, CR. (p152)
Do not disconnect/insert FFCs from/into the connectors at an angle.
C A U T I O N
Doing so may damage, short, or break the terminals in the
connector resulting in a breakdown of the elements on the board.
13. Disconnect the all connectors and FFCs from the BOARD ASSY., SUB.
14. Remove the screw that secures the grounding wire of the (MOTOR, INK
SELECTER) to the BOARD ASSY., SUB.
One C.B.S. 3 x 6 screw (6 ± 1 kgf.cm)
15. Remove the two screws that secure the STRENGTHEN PLATE, CR and remove
it. See Figure 4-86.
Two C.B.P. 3 x 6 screws (3 ± 0.5 kgf.cm)
Insert the positioning hole of the STRENGTHEN PLATE, CR over
the guide pin of the CARRIAGE, ASSY. to secure the
STRENGTHEN PLATE, CR.
DISASSEMBLY & ASSEMBLY
See Figure 4-85.
See Figure 4-86.
Disassembly/Assembly Procedure (Group 1)
BOARD ASSY., SUB
Figure 4-85. Removing the BOARD ASSY., SUB
STRENGTHEN PLATE, CR
positioning point
Figure 4-86. Removing the STRENGTHEN PLATE, CR
Revision C
C.B.S. 3 x 6
Secures the HARNESS,
Grounding Wire and
BOARD ASSY.,SUB
grounding wire
(MOTOR, INK SELECTOR)
C.B.P. 3 x 6
158