Epson Stylus Pro 3800 Service Manual page 112

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890
10. Remove the four screws that secure the BASE, ENCLOSURE to the main unit.
See Figure 4-27.
Four C.B.S. 3 x 6 screws (6 ± 1 kgf.cm)
Note that the Main Board and the Power Supply Board are stored
C A U T I O N
in the BASE, ENCLOSURE, and they are connected to the main
unit with the cables. When removing the BASE, ENCLOSURE, be
careful not to separate it too much from the main unit to avoid
damaging the cables.
11. Pull out the BASE, ENCLOSURE from the back of the printer.
Do not disconnect/insert the FFCs from/into the connectors at an
C A U T I O N
angle. Doing so may damage, short, or break the terminals in the
connector resulting in a breakdown of the elements on the board.
12. Disconnect all the connector cables and the FFCs on the BOARD ASSY., MAIN,
and remove the BASE, ENCLOSURE. (Refer to
(p113))
DISASSEMBLY & ASSEMBLY
See Figure 4-28.
"4.3.4.1 BOARD ASSY., MAIN"
Disassembly/Assembly Procedure (Group 1)
BASE, ENCLOSURE
Figure 4-27. Removing the screws from the BASE, ENCLOSURE
BOARD ASSY., MAIN
Figure 4-28. Removing the BASE, ENCLOSURE
Revision C
C.B.S. 3x6
BASE, ENCLOSURE
112