Epson Stylus Pro 3800 Service Manual page 179

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890
Be sure of the following when refolding the FFCs.
C A U T I O N
Keep the gap between the FFCs within 2 mm.
Check the medially-located FFCs (shown in light blue in the
figure below). If you see too much slack in them, move the fold
line in the direction of red arrow, and if they are tightly routed,
move the fold line in the direction of the blue arrow.
FFC
FFC
Do not make a fold on the original lines. Doing so may damage
the FFCs.
FFC
Make sure to fold the five FFCs together.
18. Fold the FFCs as shown in Figure 4-118
19. Attach the HOLDER, FFC, TUBE, and secure it with the two screws.
Two C.B.P. 3 x 8 screws (6 ± 1 kgf.cm)
20. Peel off the temporarily attached acetate tape, and remove the "Space Making
Jig".
DISASSEMBLY & ASSEMBLY
See Figure 4-118.
Original fold line
To remove slack
To loose the FFCs
NG
carefully taking up the slack.
Disassembly/Assembly Procedure (Group 1)
Within 2 mm
Figure 4-118. Installing the HOLDER, FFC, TUBE
Acetate tape
Space Making Jig
Figure 4-119. Removing the Space Making Jig
Revision C
HOLDER, FFC, TUBE
C.B.P. 3x8
179