Epson Stylus Pro 3800 Service Manual page 124

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890
4. Disconnect the connector from the MOTOR ASSY., CR.
5. Remove the two screws that secure the MOTOR ASSY., CR and remove it.
Two C.C.S. 3 x 4 screws (6
When removing the C.C.S. 3x4 screws that secure the MOTOR
C H E C K
P O I N T ASSY., CR, use a stubby screw driver or put a screwdriver (with a
140mm or longer shaft is recommended) through the holes on the
main frame as shown in
Be sure to install the MOTOR ASSY., CR to the main frame so that
the label on the MOTOR ASSY., CR faces upward.
4-44.
Since the MOTOR ASSY., CR of Epson Stylus Pro 3800/3800C/
C A U T I O N
3850 and Epson Stylus Pro 3880/3885/3890 has no compatibility, be
careful not to install the wrong one.
Whenever the MOTOR ASSY., CR is replaced, the corresponding
A D J U S T M E N T
R E Q U I R E D
adjustments must be carried out. See Chapter 5
(p208).
<Adjustment Item>
1. Write When CR Change
2. Reset When CR Motor Change
DISASSEMBLY & ASSEMBLY
±
1 kgf.cm)
Figure 4-44.
See Figure
"ADJUSTMENT"
Disassembly/Assembly Procedure (Group 1)
Overhead view
Connector
Label
MOTOR ASSY., CR
C.C.S. 3x4
Put the screwdriver
through this hole.
Figure 4-44. Removing the screws from the MOTOR ASSY., CR
Revision C
124