Epson Stylus Pro 3800 Service Manual page 131

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890
4.3.6.5 APG SENSOR
1. Remove the HOUSING, UPPER.
2. Remove the COVER, CR. (p152)
3. Remove the screw that secures the MOUNT PLATE, DETECTOR, PG, and
remove the MOUNT PLATE, DETECTOR, PG.
One C.B.P. 3 x 8 screw (5 ± 1 kgf.cm)
When installing the MOUNT PLATE, DETECTOR, PG to the
CARRIAGE, ASSY., be sure to insert the positioning holes of the
MOUNT PLATE, DETECTOR, PG over the guide pins of the
CARRIAGE, ASSY.
4. Disengage the four tabs that secure the APG SENSOR to the MOUNT PLATE,
DETECTOR, PG, and remove the APG SENSOR.
5. Disconnect the connector from the APG SENSOR.
DISASSEMBLY & ASSEMBLY
(p107)
See Figure 4-53.
Disassembly/Assembly Procedure (Group 1)
positioning points
tabs
C.B.P. 3x8
MOUNT PLATE, DETECTOR, PG
APG SENSOR connector
Figure 4-53. Removing the APG SENSOR
Revision C
131