Epson Stylus Pro 3800 Service Manual page 187

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890
4.3.10.3 MOTOR, RELEASE, ASSY.
1. Remove the HOUSING, UPPER.
2. Pull out the BASE, ENCLOSURE.
3. Disconnect the cables from CN41, CN57, CN61 on the BOARD ASSY., MAIN.
See Figure 4-29.
4. Remove the acetate tapes on the COVER, ENCLOSURE, ASSY. to release the
cables of the MOTOR, RELEASE, ASSY.
Route the cables of the MOTOR, RELEASE, ASSY. with other
cables and secure them with the acetate tapes as shown in
4-131.
5. Release the cables of the parts listed below, which are components in the
MOTOR, RELEASE, ASSY. from the two cable hooks.
MOTOR ASSY., PF
MOTOR ASSY., RELEASE
RELEASE SENSOR
DISASSEMBLY & ASSEMBLY
(p107)
(p111)
See Figure 4-131.
See Figure 4-132.
Disassembly/Assembly Procedure (Group 1)
Left rear side of the printer
Figure
COVER, ENCLOSURE, ASSY
Figure 4-131. Releasing the MOTOR, RELEASE, ASSY. Cables (1)
Left rear side of the printer
Figure 4-132. Releasing the MOTOR, RELEASE, ASSY. Cables (2)
Revision C
acetate tapes
cable hooks
187