Nut Welding; Dent Pulling With Spot Hammer - Pro Spot PHS-101 Instruction Manual

6.0

6.4 Nut Welding

Figure 6.15

6.5 DENT PULLING WITH SPOT HAMMER

Figure 6.18
34
SINGLE-SIDED WELDING
Weld-on nuts are common throughout the car body for attachments of interior,
tail lights, door moldings, etc. and are applied with ease using the Hybrid Spot.
TIP: Di erent size nuts are available from your local Pro Spot distributor
or on the web at: www.prospot.com
ASTUCE: noix de di èrentes tailles sont disponibles chez votre distributeur
local Spot Pro ou sur le web à la boutique Pro Spot en ligne.
Nuts are held in place during welding with a shrinking electrode.
1. Select Weld Power to Low (200-250ms)
2. Fit Single-Sided gun with the Shrink Electrode (Fig. 6.15).
3. Prepare the surface area by removing paint and primer.
4. Ground the working area (refer to section 6.1 "Single-Sided Welding Overview").
5. Press weld-on nut to the metal with Contact Shrinking electrode, apply some
pressure and push the trigger to weld.
6. Repeat as needed.
Spot hammer dent pulling is used to repair dents on a vehicle body, The spot
hammer welds directly onto the work area and pulls the dent.
TIP: The replaceable welding tip should last for over one thousand welds.
Contact your local distributor to order replacement tips, or order online
at: www.prospot.com
ASTUCE: Le bout de soudage remplaçable devrait durer plus d'un millier
soudures. Contactez votre distributeur local pour commander pointes de
rechange, ou commandez sur la Web Pro Spot au magasin en ligne.
1. Select Weld Power to Low/Medium (100ms)
2. Fit Single-Sided gun with the spot hammer (Fig. 6.18).
3. Prepare the dent surface area by removing paint and primer.
4. Ground the working area (refer to section 6.1 "Single-Sided Welding
Overview").
5. Position the spot hammer tip at the bottom of the dent and push the
trigger to weld the electrode onto the metal.
6. Pull out a dent then release by twisting the hammer.
7. If needed, reposition, weld and pull again.
NOTE: Check spot hammer tip periodically to make sure it is in good working
order. If the tip looks worn, replace it with a new one.
NOTE: Contrôlez le bout marteau pèriodiquement pour s'assurer qu'il est en
bon ètat de marche. Si le bout semble usè, le remplacer par un nouveau.
All Info Copyright © Pro Spot International Inc.