Moulding Clip Rivet Welding; Dent Pulling With Washers And Slide Hammer With Hook - Pro Spot PHS-101 Instruction Manual

6.0

6.6 MOULDING CLIP RIVET WELDING

Figure 6.21

6.7 DENT PULLING WITH WASHERS AND SLIDE HAMMER WITH HOOK

Figure 6.24
SINGLE-SIDED WELDING
This function will weld on factory type clips for the window moulding. The clips
that hold the moulding do not, usually, come on the replacement parts.
Rivets are held in place during welding with magnetic adapter electrode.
1. Select Weld Power to Low (100ms) Recommendation: When welding Clip Rivets,
move the ground cable as far away from the weld area as possible.
2. Select Rivet Welding Program by pressing the Left or Right Navigation Buttons
3. Choose weld power level by pressing the "Next Program" button repeatedly.
4. Fit Single-Sided gun with the magnetic rivet adapter (Fit. 6.21).
5. Insert rivet into the adapter ( Fig. 6.21).
6. Prepare the surface area by removing paint and primer.
7. Ground the working area (refer to section 6.1 "Single-Sided Welding Overview").
8. Position Single-Sided gun over work area and push the trigger to weld.
9. Repeat as needed.
The slide hammer with hook (optional) can be used in conjunction with washers
to repair car body dents.
TIP: You can purchase a slide hammer with hook from your local Pro Spot
distributor or on the web at: www.prospot.com
ASTUCE: Vous pouvez acheter un marteau glissant avec crochet de votre
distributeur locale Pro Spot ou sur le web à la boutique Pro Spot en ligne.
Washers are held in place during welding with magnetic adapter electrode.
1. Select Weld Power to Low (175ms)
2. Fit Single-Sided gun with the magnetic washer adapter (Fig. 6.24).
3. Insert washer into the adapter (Fig. 6.24).
4. Prepare the dent surface area by removing paint and primer.
When welding on washers, you only need to clean the area where the washer
touches the metal since the grounding system is connected through a seperate
cable.
5. Gound the working area (refer to section 6.1 "Single-Sided Welding Overview").
6. Position the washer at the bottom of the dent and push the trigger to weld the
washer onto the metal.
7. Hook the washer with the slide hammer and pull the dent out.
8. Repeat as needed.
TIP: You can, also, pull multiple washers by welding on a tow of washers at
the bottom of the dent, inserting a rod through the washers and pulling
the rod with the slide hammer with hook.
ASTUCE: Vous pouvez, ègalement, tirer plusieurs rondelles par soudage sur
une rangèe de rondelles au bas de la Dent, insertant une baguette par les
rondelles et en tirant la tige avec le marteau glissqnt avec crochet.
All Info Copyright © Pro Spot International Inc. 35