System Menu And Advanced Features; Battery Status; Last Weld Info; Weld Count - Pro Spot PHS-101 Instruction Manual

4.0
Home Screen:
The home screen displays the weld power, weld time, cooling status, and provides an entry point
to the System Menu.
To set the weld time:
1. Rotate the weld control button to move the
2. Press the Weld Control Button once to enter editing mode, then rotate the knob to adjust weld time in
5 millisecond increments.
3. Once the desired time is shown press the Weld Control Button once to save the setting and exit
editing mode.
To set the weld power, move the
procedure as shown above.
To turn cooling on or o , move the
Control Button to toggle the setting.

4.7 SYSTEM MENU AND ADVANCED FEATURES

By clicking on the "System Menu" option at the bottom of the Home screen, the user can access all of
the more advanced features and settings available on the PHS-101. These features include diagnostics,
operator alerts, and ne-tuning parameters that allow the user to customize the welder to best t their
application.

4.7.1 Battery Status

Selecting this menu option will display the voltage and charging current for all 4 batteries. If the
chargers are unplugged, the charge current will show 0. Pressing the Weld Control Button again will
return the user to the Home screen.

4.7.2 Last Weld Info

The PHS-101 has an integrated current sensor that monitors the true weld current and stores the results
of the last weld for diagnostic purposes. Selecting Last Weld Info will display the recorded voltage and
weld current for the last weld. Pressing the Weld Control Button again will return the user to the Home
screen.

4.7.3 Weld Count

Selecting this menu option will display the total number of welds (both Double and Single-Sided) that
have been performed on the welder. This is similar to an odometer in that it cannot be reset, even by
disconnecting the batteries from the unit. Pressing the Weld Control Button again will return the user
to the Home screen.
OPERATION
cursor to the WELD TIME line on the LCD.
cursor to the WELD POWER line of the LCD, then use the same
cursor to the COOLING line of the LCD, then press the Weld
All Info Copyright © Pro Spot International Inc.
-
17