Connection Of Pneumatic Air Supply - Pro Spot PHS-101 Instruction Manual

3.0 INSTALLATION

3.5 CONNECTION OF PNEUMATIC AIR SUPPLY

The Hybrid Spot welder must be connected to a pneumatic air network. (100 PSI to 130 PSI)
1. Connect the welder to the air supply via the threaded input port at the rear of the welder using a
standard connector.
2. If not already set, adjust the air pressure setting on the welder front panel to 90 PSI (4-5 bar)
(refer to section 4.5 "Setting the pneumatic air pressure").
IMPORTANT! The air must be clean and free from oil and moisture. Use a lter.
IMPORTANT! L'air doit être propre sans huile et humidité, Utilisez un ltre.
Air supply port
Figure 3.2
12 All Info Copyright © Pro Spot International Inc.