Configuring Console User Interface - Huawei V300R005 Configuration Manual

Quidway NetEngine80
Configuration Guide - Basic Configurations

5.2 Configuring Console User Interface

5.2.1 Establishing the Configuration Task
Applicable Environment
If you need to maintain a router on a local device, the console user interface is required.
Pre-configuration Tasks
Before configuring console user interface, complete the following tasks:
Data Preparation
To configure console user-interface, you need the following data.
No.
1
2
3
4
Configuration Procedures
To configure a console interface, complete the following procedures.
No.
1
2
3
4
Issue 04 (2009-12-20)
For the configuration of FTP user, refer to the Chapter 8 "FTP, TFTP and XModem."
For the configuration of PPP user, refer to Quidway NetEngine80 Core Router Configuration Guide
- Security.
Powering on the router
Connecting the PC with the router properly
Data
Transmission rate, flow-control mode, checksum mode, stop bit, and data bit
Idle timeout period for user, screen length of terminal, and the size of history
command buffer
User priority
User authentication method, user name, and password
All the default values of the data are stored on the router and does not need additional configuration.
Procedure
Configuring Console Interface Attributes
Setting Console Terminal Attributes
Configuring the User Interface Priority
Configuring User Authentication
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 User Management
5-5