Configuration Procedures; Establishing The Physical Connection; Logging In To The Router - Huawei V300R005 Configuration Manual

Quidway NetEngine80
Configuration Guide - Basic Configurations
Pre-configuration Tasks
Before configuring the router through the console port, complete the following tasks:
Data Preparation
To configure the router through the Console port, you need the following data.
No.
1

Configuration Procedures

To configure the router through the Console port, complete the following configuration
procedures.
No.
1
2
3

2.2.2 Establishing the Physical Connection

Do as follows on the router:
Step 1 Connect the COM port on the PC and the console port on the router by cable.
Step 2 Power on all devices to perform a self-check.
----End
2.2.3 Configuring Terminals
Do as follows on the PC:
Step 1 Run the terminal emulation program on the PC, setting the communication parameter of the
terminal to 9600 bps, data bit to 8, stop bit to 1. Specify no parity and no flow control.
----End

2.2.4 Logging In to the Router

Do as follows on the PC:
Issue 04 (2009-12-20)
Preparing the PC/terminal (including serial port and RS-232 cable)
Installing terminal emulation program on the PC (such as Windows XP hyper terminal)
Data
Terminal communication parameters (including baud rate, data bit, parity, stop
bit and flow control)
Procedure
Establishing the Physical Connection
Configuring Terminals
Logging In to the Router
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Establishment of the Configuration Environment
2-3