Configuring A Cleaning Cycle For The Air Filter; Remonitoring The Cleaning Cycle Of The Air Filter; Checking The Configuration - Huawei V300R005 Configuration Manual

Quidway NetEngine80
Configuration Guide - Basic Configurations
The checking of the air filter based on the device temperature is configured.
By default, the checking of the air filter based on the device temperature is enabled.
----End

10.5.3 Configuring a Cleaning Cycle for the Air Filter

Do as follows on the router:
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
dustproof check-timer day INTEGER
The cleaning cycle for the air filtered is configured.
----End

10.5.4 Remonitoring the Cleaning Cycle of the Air Filter

The system generates an alarm about cleaning the air filter. After ensuring that the air filter is
cleaned or does not need to be cleaned, you need to clear the alarm and remonitor the cleaning
cycle of the air filter.
Do as follows on the router:
Step 1 Run:
reset dustproof run-time
The alarm is cleared. The cleaning cycle of the air filter is monitored.
----End

10.5.5 Checking the Configuration

Run the following commands to check the previous configuration.
Action
View the information about the
air filter.
<Quidway> display dustproof
Clean Dustproof-Net cycle : 365(days)
Last clean date
Issue 04 (2009-12-20)
The air filter is a component without memory. All the monitored information is saved on the MPU,
which may be inserted, removed, switched, or replaced during usage. Therefore, the monitoring cycle
may differ from the set cycle, but this does not affect the monitoring function.
: 2009/02/07
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Command
display dustproof
10 Router Maintenance
10-9