Configuring The Router To Be The Ftp Server; Establishing The Configuration Task - Huawei V300R005 Configuration Manual

Quidway NetEngine80
Configuration Guide - Basic Configurations
NE80 provides the function of XModem receiving program, which can be applied to the AUX
port and supports 128-byte packets and CRC. The function of XModem sending program is
automatically included in the HyperTerminal.

8.2 Configuring the Router to be the FTP Server

8.2.1 Establishing the Configuration Task

Applicable Environment
When the router serves as the FTP server, after the client logs in to the router through FTP, the
user can transport files between the client and the server.
Pre-configuration Tasks
Before configuring the FTP server, complete the following tasks:
Data Preparation
To configure FTP, you need the following data.
No.
1
2
3
Configuration Procedures
To configure an FTP server, you need to take following steps.
No.
1
2
Issue 04 (2009-12-20)
The receiving program sends the acknowledgement character after the check passes. The
sending program then sends the next packet.
If the check fails, the receiving program sends the deny character and the sending
program retransmits the packet.
The XModem function is supported only by the AUX port.
XModem does not support simultaneous operations of multiple users.
Powering on the router
Connecting the FTP client with the server
Data
The timeout time of the FTP server
FTP username and password
The file directory authorized to the FTP user
Procedure
Configuring the source address of FTP server
Enabling the FTP Server
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 FTP, TFTP and XModem
8-3