Logging In From The Telnet Client; Configuring Login User Parameters; Logging In To The Router Through The Aux Port - Huawei V300R005 Configuration Manual

Quidway NetEngine80
Configuration Guide - Basic Configurations
2.3.2 Establishing the Physical Connection
Connect the router and the PC directly or connect the router and the PC respectively to the
network through the network cable.

2.3.3 Configuring Login User Parameters

Do as follows on the router:
Step 1 Configure the authentication mode of login users.
Step 2 Configure the authority limitation of login user.
For details, refer to Chapter 5 "User Management" in the Quidway NetEngine80 Core Router
- Basic Configurations.
----End

2.3.4 Logging In from the Telnet Client

Do as follows on the PC:
Step 1 Run the Telnet client program on the PC, and input the IP address of the interface on the
destination router that provides the Telnet service.
Step 2 Enter the user name and password in the login window. After authentication, a command line
prompt such as <Quidway> appears. Now enter the configuration environment in the user
view.
----End

2.4 Logging In to the Router Through the AUX Port

2.4.1 Establishing the Configuration Task
Applicable Environment
If you cannot configure the router by local login and there is no reachable route to other
routers, connect the serial port of the PC and the AUX port of the router through the Modem.
Pre-configuration Tasks
Before configuring the router through the AUX port dialup, complete the following tasks:
Data Preparation
To configure the router, you need the following data.
Issue 04 (2009-12-20)
Preparing the PC/terminal (including the serial port and RS-232 cable)
Preparing the PC terminal emulation program (such as Windows XP hyper terminal)
Preparing two Modems
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Establishment of the Configuration Environment
2-5