Logging In To The Router Using Telnet - Huawei AR150 SERIES Quick Start Manual

Huawei AR150&200 Series Enterprise Routers
Quick Start Guide
Step 5 Press Enter on the subsequent dialog boxes until the command line prompt of the user view,
such as <Huawei>, is displayed.
You can run commands to configure the router. Enter a question mark (?) to see a list of available
commands.
----End

3.3 Logging In to the Router Using Telnet

This section describes how to log in to the router using Telnet.
Procedure
Step 1 Connect a PC to any LAN port of the router with a network cable.
Step 2 Configure an IP address for the PC. The IP address must be on the network segment
192.168.1.0/24, but cannot be 192.168.1.1.
After the configuration is complete, run the ping 192.168.1.1 command on the PC to check
whether the router can be pinged successfully. If the ping operation succeeds, the connection
has been set up successfully. If the ping operation fails, the connection failed to be established.
Check whether the network cable is working properly. If not, replace the network cable.
Step 3 Access the command line window on the PC. For example, if the PC runs Windows XP, choose
Start > Run and enter cmd in the displayed dialog box.
Step 4 Run the telnet 192.168.1.1 command to log in to the router.
Step 5 Enter the default user name and password admin. If the user interface is displayed, you logged
in successfully.
When you log in for the first time, the following information is displayed:
Username:admin
Password:
<Huawei>
----End
Issue 03 (2012-06-10) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Logging In to the Router
29