Wing : Wireless Control ( Option ); Installing The Wing; Figure 115: A W - Gamatronic Power+ User Manual

Gamatronic Electronic Industries Ltd.
9. W : W
ING
The POWER + system includes an option for wireless control and management, using
Gamatronic's Wing.
The Wing allows real-time detection of power system faults and immediately notifies selected
recipients (control center, technician, etc.) detailing the faults.
The Wing consists of:

Wing board.

SIM board.

Antenna.

D9-D9 cable (for RS232 between the Power+ and the Wing).

Dc power cable (banana plugs on both ends).
9.1

Installing the Wing

Note: The instructions in this section are for a Wing unit that has been ordered
specifically for use with a Power+ system. If your Wing was ordered for use with another type
of system, it does not contain the appropriate software for use with a Power+ system and you
should contact your Gamatronic representative if you wish to convert it for Power+ use.
To install a Wing unit for use with a Power+ system:
1. Take the Wing and press the button on the left side of the SIM slot to unlock the SIM card
holder; remove the SIM card holder from the Wing.
2. Place your SIM card (which you obtained from your cellular service provider) in the SIM card
holder and slide the SIM card holder gently and firmly back into the Wing.
3. Attach the supplied cellular antenna to the Wing.
4. Connect the Wing to the D9 socket labeled "Wing" on the left rear side of the controller using
the supplied D9-D9 cable.
68
POWER + RM 50
VA, N.Am. Std. – User Guide, Release 1.4
K
C
IRELESS
A Wing unit connected to the PowerPlus
Figure 115:
(
ONTROL OPTION
)