Figure 15: Default Screen, With No Load, For 3-Phase Output - Gamatronic Power+ User Manual

Gamatronic Electronic Industries Ltd.
Finally the normal default screen is displayed as in Figure 15. Verify that the correct
4.
number of phases are displayed:
IMPORTANT NOTE: Your POWER+ System has been delivered to you with the output
5.
voltage set to 120 Vac (phase-to-neutral), and the frequency set to 60 Hz. If the
voltage or frequency of your local power mains is different, you must now adjust the
POWER+ output voltage and/or frequency to match your local environment.
(If 120 Vac / 60 Hz is your standard local voltage and frequency, continue with section 4.8.3
below.)
4.8.1 Changing the Power+ output voltage
1. Press the Enter key to display the main menu.
2. Select the "Setup" option.
3. Enter the password. (The default password is pressing the "left-arrow" key eight times.
Then press the Enter key.
4. Select the "Module configuration" option.
5. Select the "Module/s voltage" option. The following screen is displayed.
6. Use the up/down arrow keys to move the blinking cursor to the desired voltage value, then
press "Enter". The characters "(selected)" appear to the right of your choice.
7. Press "Esc".
If you need to change the frequency from the default 60 Hz, continue with section 4.8.2;
otherwise, continue with section 4.8.3.
4.8.2 Changing the Power+ output frequency
1. Press the Enter key to display the main menu.
2. Select the "Setup" option.
3. Enter the password. (The default password is pressing the "left-arrow" key eight times.
Then press the Enter key.
4. Select the "Module configuration" option.
5. Select the "Module/s frequency" option.
POWER + RM 50

Figure 15: Default screen, with no load, for 3-phase output

VA, N.Am. Std. – User Guide, Release 1.4
K
29