Step 6. Run The Philips Upgrade Wizard; Compatibility - Philips IntelliVue Telemetry System Infrastructure Installation And Service Manual

Chapter 3: Installing and Configuring the ITS

Step 6. Run the Philips Upgrade Wizard.

Run the Philips Upgrade Wizard to check and verify the APCs you added to the
network are running the same version firmware. If any configuration modifications
are made, run the Philips Upgrade Wizard again.
The Philips Upgrade Wizard has been designed to automate and simplify the
upgrade process for ITS APC and APs. In addition to upgrading the firmware on
these ITS components, you can use the wizard to:
• verify that APCs on your network are configured correctly
• display warning and error messages that you may use to troubleshoot any
configuration errors that may exist on your ITS network

Compatibility

The Philips Upgrade Wizard requires supported, and compatible AP and APC
firmware. Note the compatibility requirements listed in Table 3-2.
Caution Use of Versions A.00.08 and older of the Upgrade Wizard must be discontinued.
Upgrade
Wizard Version
(A.00.16)
Release J
(A.00.08)
Release H
(A.00.07)
Release G
(A.00.0x)
Release F
3-16
Table 3-1: Upgrade Wizard and APC/AP Compatibility
ITS Infrastructure Firmware Versions
Release J Release J
2.4GHz 1.4GHz Core
AP (B.00.08) AP (A.00.19)
APC (B.00.18) APC (B.00.18)
Compatible Compatible
Not Compatible Not Compatible
Warning: May Warning: May
Cause AP Fault Cause AP Fault
Not Compatible Not Compatible
Warning: May Warning: May
Cause AP Fault Cause AP Fault
Not Compatible Not Compatible
Warning: May Warning: May
Cause AP Fault Cause AP Fault
Release H Release G
1.4GHz 1.4GHz
AP (A.00.54) AP (A.00.52)
APC (A.00.34) APC (A.00.32)
Compatible Compatible
Compatible Compatible
Not Compatible Compatible
Not Compatible Not Compatible
Release F
1.4GHz
AP (A.00.50)
APC (A.00.29)
Compatible
Compatible
Compatible
Compatible