2.4 Ghz Default Ap Configuration Worksheet; Setting Descriptions - Philips IntelliVue Telemetry System Infrastructure Installation And Service Manual

2.4 GHz Default AP Configuration Worksheet

Refer to the following setting descriptions when completing the 2.4 GHz Access
Setting
Descriptions Point Configuration Worksheet. Use the information you record in this worksheet
with the procedure entitled "Step 9. Add APs to the Network." on page 3-37.
• Partnered APC - "Any"
• Default Group - Always Smart-hopping
• Radio Regulations - Specify the radio regulations that apply to the country in
which you are installing the 2.4 GHz ITS. Possible Radio Regulation choices are:
• ETSI - Europe, South America, Asia, Asia Pacific, and Africa
• FCC - Taiwan
• RSS-210 - Canada/North America
• AS/NZ - Australia/New Zealand
• ARIB - Japan
• Frequency Plan - Specify the 802.11 channel configuration with which the 2.4
GHz ITS will co-exist. Possible Frequency Plan choices are:
Co-exist with 802.11
Channels 1, 6, 11
Co-exist with 802.11
Channels 1, 7, 13
Advanced
1
43 can be used instead.
2
34 can be used instead.
If you select Advanced, then you must specify a minimum of three and a
maximum of six channels (six is recommended) for use by the 2.4 GHz ITS.
• ZigBee channel used for medical - Specify the ZigBee channel used for medical
purposes at the installation site. Possible selections are channels 11 to 26.
Default: None.
• RF Access Code - Enter number between 1 and 254 to be used as the Access
Code for the system (site specific). Do not use 0 or 255, these are reserved for
special use. For use of multiple RF Access Codes, refer to Appendix A, "Installing
Multiple ITSs at a Single Hospital Site."
IntelliVue Telemetry System Infrastructure Installation and Service Guide
Frequency Plan
14, 28, 44, 45, 46, 47
14, 15,16, 31, 32, 33
Any set (min 3, max 6) of 2.4 GHz
ITS channels from 0 - 47,
excluding any that have been
disabled by the ZigBee selection.
-
If any one of this set of six channels is disabled by the ZigBee channel selection, then channel
-
If any one of this set of six channels is disabled by the ZigBee channel selection, then channel
Completing ITS Installation Worksheets
2.4 GHz ITS Channels Configured for Use
FCC,ARIB,RSS-210
1
2
ETSI
14, 28, 43, 44, 45, 46
2
14, 15, 16, 31, 32, 33
Any set (min 3, max 6) of 2.4 GHz
ITS channels from 1 - 46,
excluding any that have been
disabled by the ZigBee selection
2-33