Table of Contents
Advertisement
• Remote Antenna - The Core AP provides two LEDs on each RJ-45 UTP cable
connector that provides status on a connected Remote Antenna:
-
-
The Remote Antenna provides the following status LEDs.
• Remote Antenna Status LEDs - The green and yellow LEDs above the
RJ-45 UTP cable connector to the Core AP provide status on the Remote
Antenna as summarized below.
Core AP Mounting Options
Wall-mounting hardware is standard. An optional above/below ceiling mount kit is
available.
Access Point Controller
The multi-functional Philips Access Point Controller (APC) (Figure 1-6) controls the
data flow of patient-worn transceivers as the patients move about the coverage
area between the IntelliVue Access Points. It also can be used to configure
parameters of the APs—all via its Graphical User Interface (GUI).
Power Receptacle
The APC provides System Alerts such as loss of synchronization, high data loss, AP
hardware failure, and over capacity. Additionally, when redundant APCs are
installed, the APC will provide a System Alert for APC hardware or software failure. It
can be rack mounted (recommended) or placed freestanding on a flat surface.
IntelliVue Telemetry System Infrastructure Installation and Service Guide
RA Connection - Lights GREEN to indicate a RA is connected to the Core AP.
RA Power - Lights YELLOW to indicate connected RA is receiving power from
the Core AP.
Table 1-3: Remote Antenna Status LEDs
Green/Yellow LEDs
Off/Off
Flash Green/Yellow
Solid Green/Yellow
Power LED
Serial Port
Figure 1-6: IntelliVue Telemetry System Access Point Controller
IntelliVue Telemetry System Infrastructure Components
Remote Antenna Status
No connection to or power from Core AP.
Remote Antenna is running self-test/Power on.
Connection to Core AP is Successful/Power On.
This is the expected normal operational status.
Network Utilization LEDs
100 Base-T
Link/ACT
100-240V~
50/60 Hz,1.5A
Ethernet Port
Link/ACT LED
100 Base-T LED
1-9
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
