Chapter 3: Installing And Configuring The Its - Philips IntelliVue Telemetry System Infrastructure Installation And Service Manual

3
IntelliVue Telemetry System Infrastructure Installation and Service Guide
Installing and Configuring the ITS
This chapter provides procedures to physically install the IntelliVue
Telemetry System components and configure the ITS operational settings
for use at the installation site, and includes:
• High-level ITS Installation and Configuration Procedure
• Step 1. Complete the ITS Installation Worksheets.
• Step 2. Install the ITS Infrastructure Components.
• Step 3. Set Up Your Service PC.
• Step 4. Perform Initial Configuration of the APCs to be Installed.
• Step 5. Add the APCs to the Network.
• Step 6. Run the Philips Upgrade Wizard.
• Step 7. Verify and Configure Important ITS Settings via the APC
Interface.
• Step 8. Run the Philips Upgrade Wizard Again.
• Step 9. Add APs to the Network.
• Step 10. Rename Installed APs and Remote Antennas.
• Step 11. Run the Philips Upgrade Wizard Again.
• Step 12. Export the ITS Configuration to a Disk File.
• Step 13. Restore your Service PC to its Original Settings.
• Step 14. Install ITS Bedside Monitors and Patient-worn Transceivers.
3-1