Copying The Upgrade Wizard Files To Your Pc - Philips IntelliVue Telemetry System Infrastructure Installation And Service Manual

g) Mark the Use the following IP Address radio button, enter the following
h) Click OK at each open dialog to close the dialogs and save the Local Area

Copying the Upgrade Wizard files to your PC

To install the Philips Upgrade Wizard, and ITS AP and APC image files on the service
PC that is connected to the ITS subnet:
1. Copy the newest version of the Philips Upgrade Wizard wizard (Version A.00.14
or greater) from the Network Infrastructure Tools CD-ROM to your PC:
a) Place the Network Infrastructure Tools CD in the PC's CD ROM drive.
b) Create a folder on a local drive on your PC; for example:
c) Copy
2. Copy the newest versions of APC and AP firmware files from the Network
Infrastructure Tools CD-ROM (Note that earlier releases of the APC and AP
firmware also reside on the Network Infrastructure Tools CD-ROM.):
a) Create a version-specific folder inside the
IntelliVue Telemetry System Infrastructure Installation and Service Guide
The Internet Protocol Properties dialog appears.
Routed or Non-Routed settings, and then click OK:
Non-routed Configuration, where "n" represents the ICN Database Domain
Number:
- IP address - 172.31.(n).4
- Subnet mask - 255.255.248.0
- Default gateway - 172.31.(n+3).0
Routed Configuration:
- IP address - 172.31.240.4
- Subnet mask - 255.255.240.0
- Default gateway - 172.31.240.1
Connection settings.
C:\TelemetryUpgrader\
D:\Tools\PHILIPS AP AND APC UPGRADER TOOL\UPGRADER.EXE
C:\TelemetryUpgrader\UPGRADER.EXE
each version of the APC you need to support or upgrade; for example:
Step 3. Set Up Your Service PC.
.
C:\TelemetryUpgrader
to
folder for
3-9