Philips IntelliVue Telemetry System Infrastructure Installation And Service Manual page 108

Chapter 3: Installing and Configuring the ITS
• Set the RF Access Code field as documented in the 1.4 GHz Access Point
• Set the Subnet Mask and Default Gateway fields as documented in the 1.4
In the 2.4 GHz AP Group Configuration Basic Settings screen, set the following
2.4 GHz AP
Group configurations for this AP Group:
Configuration
• Select the appropriate APC for this AP group from the Partnered AP
Basic Settings
In the 2.4 GHz AP Group Configuration Basic Settings screen, verify the
following configurations for this AP Group. If they are not correct, delete the AP
group and then edit the AP default settings (see page 3-25):
• Select the Radio Regulations from the drop-down list that apply to the
• Select the Frequency Plan from the drop-down list to specify the 802.11
• Select the ZigBee channel used for medical purposes at the installation site
• Set the RF Access Code field as documented in the 2.4 GHz Access Point
• Set the Subnet Mask and Default Gateway fields as documented in the 2.4
6. Click SAVE and then verify that the AP Group Basic Configuration settings are
correct.
7. Select the ALERTS SETTINGS tab.
3-30
Default Configuration Worksheet, and set the Enable Box to CHECKED.
GHz Access Point Default Configuration Worksheet.
Controller drop-down list. Refer to your completed AP Group Configuration
Worksheet.
country in which you are installing the 2.4 GHz ITS as documented in the
2.4 GHz AP Default Configuration Worksheet.
channel configuration with which the 2.4 GHz ITS will co-exist.
from the drop-down list as documented in the 2.4 GHz AP Default
Configuration Worksheet.
Default Configuration Worksheet, and set the Enable Box to CHECKED.
GHz Access Point Default Configuration Worksheet.
Figure 3-15: AP Group Configuration Alert Settings