Philips IntelliVue Telemetry System Infrastructure Installation And Service Manual page 33

• Multiple ITSs at a single hospital are supported only if the topology,
configuration, and Sync Network requirements listed in Appendix A are met.
Figure 1-11 illustrates supported and non-supported ITS installations within a non-
routed ICN topology.
Supported:
(Multiple ITSs at a single
location are supported
only if the Topology,
Configuration, and Sync
Net requirements listed
in Appendix A are met.)
Not Supported:
Refer to Table 1-9 for a list of the device IP address assignments used in a non-
routed ICN configuration where the ITS infrastructure is installed on the ICN subnet.
Note the following regarding Table 1-9:
• "n" represents the network number and starts at 0 for single Database Domain
ICN systems. This variable increments by 8 from there for additional ICN
Database Domains. For example, for DBS 2, "n" would equal 8, for DBS 3, "n"
would equal 16, and so on.
IntelliVue Telemetry System Infrastructure Installation and Service Guide
Figure 1-11: Supported and Non-Supported ITS Non-routed ICN Installations
Supported Topologies and System Limits
1-19