Philips IntelliVue Telemetry System Infrastructure Installation And Service Manual page 6

Contents
Chapter 4: Expanding or Modifying an Installed ITS
Expanding an Installed IntelliVue Telemetry System . . . . . . . . . . . . . . . . . . . . . . 4-2
General ITS Expansion Guidelines . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-4
APC Upgrade/Expansion Guidelines . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-5
Adding APs to an Installed ITS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-6
Adding an AP via Auto-Registration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-7
Adding an AP via Manual MAC Address Input. . . . . . . . . . . . . . . . . . . . . . . . 4-10
Renaming Newly Installed APs and Remote Antennas . . . . . . . . . . . . . . . . 4-12
Adding APCs to an Existing ITS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-13
Adding New AP Groups to an Existing ITS Configuration . . . . . . . . . . . . . . . . . . 4-15
Replacing an AP, Remote Antenna, or APC in an Existing System. . . . . . . . . . . 4-17
Replacing an ITS Access Point . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-18
Replacing a Remote Antenna. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-18
Replacing an ITS APC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-19
Chapter 5: Troubleshooting and Testing
ITS Access Point Test and Inspection Procedures . . . . . . . . . . . . . . . . . . . . . . . . 5-2
ITS Access Point Controller Test and Inspection Procedures . . . . . . . . . . . . . . . . 5-3
ITS Sync Unit Test and Inspection Procedures . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-4
ITS Power over Ethernet Unit Test and Inspection Procedures . . . . . . . . . . . . . . 5-5
ITS Uninterruptible Power Supply Test and Inspection Procedures. . . . . . . . . . . 5-6
ITS Network Switch Test and Inspection Procedures . . . . . . . . . . . . . . . . . . . . . . 5-7
Troubleshooting Known Issues. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-8
Importing ITS Configuration Files . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-10
Appendix A: Installing Multiple ITSs at a Single Hospital Site
General Requirements for Installing Multiple ITSs at a Site. . . . . . . . . . . . . . . . . A-2
Transceiver Installation Requirements for Multiple ITSs . . . . . . . . . . . . . . . . . . . A-3
Patient-worn Transceivers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . A-3
Extra MAC addresses in the Label Assignment Screen . . . . . . . . . . . . . . . . . A-3
Sync Network Requirements for Multiple ITSs . . . . . . . . . . . . . . . . . . . . . . . . . . . A-4
vi
Add the New AP Groups . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-15
Configure the New AP Groups . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-16
Replacing a Master APC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-19
Replacing a Slave APC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-20