Its Access Point Test And Inspection Procedures - Philips IntelliVue Telemetry System Infrastructure Installation And Service Manual

Chapter 5: Troubleshooting and Testing

ITS Access Point Test and Inspection Procedures

Table 5-1 lists which tests you must perform when performing service events on
IntelliVue Telemetry System Access Points.
Installation
Preventive Maintenance
Any component repair or replacement
Hardware Upgrade
Software Upgrade
All other Service Events
Test Block
Name
AP Visual Inspect all system components for obvious damage.
Visually inspect all system components, Remote
Antennas, cables, and connectors. Check for signs of
abrasion, wear, or other damage. Check the fixed
antennas for secure connection, proper orientation and
direction.
AP Power On With power connected to each active Network device,
observe that all lights visible on the front panel are in
proper status and that no error conditions are shown.
See Standard AP LED descriptions on page 1-5.
Verify that Link and Power/Sync LEDs on Core AP are lit
GREEN. Verify that GREEN and YELLOW status LEDS on
Remote Antennas are lit solid. See Cluster AP LED
descriptions on page 1-8.
Note that for 1.4 GHz Core APs and 2.4 GHz Standard
APs, you can view the Power, Network, and Radio LEDs
from the AP Status page in the APC web interface.
Remote Antenna status can be checked from the
Names tab in the APC web interface.
AP Performance Does the AP appear in the AP web browser
management screens? Does data from a wireless
device appear at the Information Center?
AP Revision Does the revision reported in the APC web browser
Check screen match the revision loaded? Run the Philips
Upgrade Wizard to check and verify final configurations.
AP Safety No safety test is required
5-2
Table 5-1: ITS Access Point Test and Inspection Requirements
When Performing this Service Event...
Table 5-2: ITS Access Point Test and Inspection Matrix
Test or Inspection to Perform
Complete These Required Test(s)
Visual, Power On, Performance
N/A
Power On, Performance
N/A
Power On, Performance, Revision Check
Visual, Power On, Performance
Expected Results
No visible damage
Devices power up
into expected status;
no error indications
are shown.
Expected answers
are "Yes". If so,
Performance test
passed.
Expected answer is
"Yes". If so, Revision
Check test passed.
Information to
Record on
Service Record
V:P or V:F
where:
P = Pass
F = Fail
PO:P or PO:F
where:
P = Pass
F = Fail
P:P or P:F
where:
P = Pass
F = Fail
RC:P or RC:F
where:
P = Pass
F = Fail
S:NA
where:
NA=Not
Applicable