Philips IntelliVue Telemetry System Infrastructure Installation And Service Manual page 177

Manufacturer contact information
MASTER/SLAVE toggle switch on Sync Unit 1-12
Maximum AP to switch cable length 2-13
Microwave ovens, as 2.4 GHz interference source 2-19
Mounting options 3-2
Mounting options, access point 1-9
Mounting options, standard access point 1-6
N
Network LED 1-5, 1-8
Network Utilization LEDs 1-10
Non-routed ICN topology 1-18
Non-routed ICN topology, assigning device IP addresses on 1-20
Notational conventions
O
Organization of content in this document
Overview of the ITS 1-2
P
Part numbers 1-28
Partnered AP Controller 3-25, 3-27, 3-29, 3-30, 3-38, 3-39
Partnered APC 2-32, 2-33
Patient environment, boundaries of 2-2
Philips Smart-hopping technology 1-3
Physical Address 4-11
Physical space assessment, performing 2-4
Power draw ratings for ITS devices 1-13
Power LED 1-10
Power over Ethernet (PoE) Unit
description of 1-12
illustration of 1-12
testing 5-5
Power requirements for ITS devices 1-24
Power/Sync LED 1-5, 1-8
R
Rack-mounting ITS infrastructure components 3-4
Radio compliance specifications 1-26
Radio LED 1-5, 1-8
Radio Regulations 2-33, 3-27, 3-30, 3-39
Radius of coverage cells, placing on a floorplan 2-7
Radius of coverage for APs 2-4
Range 5, settings for 3-25
Related documentation
Remote Antenna description 1-6
Remote Antenna, replacing 4-18
IntelliVue Telemetry System Infrastructure Installation and Service Guide
ii
xi
x
xi
Index
Index-5