Its Sync Unit Test And Inspection Procedures - Philips IntelliVue Telemetry System Infrastructure Installation And Service Manual

Chapter 5: Troubleshooting and Testing

ITS Sync Unit Test and Inspection Procedures

Table 5-5 lists which tests you must perform when performing service events on
IntelliVue Telemetry System Sync Unit.
Installation
Preventive Maintenance
Any component repair or replacement
Hardware Upgrade
Software Upgrade
All other Service Events
Test Block
Name
Sync Unit Visual
Sync Unit
Power On
Sync Unit
Performance
Sync Unit
Revision Check
Sync Unit
Safety
5-4
Table 5-5: ITS Sync Unit Test and Inspection Requirements
When Performing this
Service Event...
Table 5-6: ITS Sync Unit Test and Inspection Matrix
Test or Inspection to Perform
Inspect all system components for obvious
damage. Visually inspect all system
components, cables, and connectors. Check
for signs of abrasion, wear, or other damage.
With power connected to each active Network
device, observe that all lights visible on the
front panel are in proper status and that no
error conditions are shown.
Following are normal conditions for each LED:
- Power LED - On GREEN
- Ext Ref LED - Off
- Sync In LED - if Sync is Master - Off
- if Sync is Slave - On
Are there active Sync Unit alerts in Wireless
Status Log?
Do all associated APs appear as registered in
the APC web browser management screens?
No Revision Check is required.
No safety test is required
Complete These Required Test(s)
Visual, Power On, Performance
N/A
Power On, Performance
N/A
N/A
Visual, Power On, Performance
Expected Results
No visible damage
Devices power up
into expected
status; no error
indications are
shown.
Expected answer is
"No."
Expected answer is
"Yes". If so,
Performance test
passed.
Information to
Record on
Service Record
V:P or V:F
where:
P = Pass
F = Fail
PO:P or PO:F
where:
P = Pass
F = Fail
P:P or P:F
where:
P = Pass
F = Fail
RC:NA
where:
NA=Not
Applicable
S:NA
where:
NA=Not
Applicable