Step 14. Install Its Bedside Monitors And Patient-Worn Transceivers - Philips IntelliVue Telemetry System Infrastructure Installation And Service Manual

Chapter 3: Installing and Configuring the ITS

Step 14. Install ITS Bedside Monitors and Patient-worn Transceivers.

Once you have completed steps 1 to 12 to install the ITS, you can now add ITS
infrastructure and wireless clients into the Configuration Wizard. You can then
configure the wireless clients for use by using the Label Assignment function from
the DBS or IIC.
Note that if the IIC and DBS are running System J or greater, you can enter the ITS
infrastructure devices into the Configuration Wizard by running the network Scan
function on the Database Server/Standalone IntelliVue Information Center.
Turn on patient-worn transceivers and wireless bedside monitors that have been
configured for use (i.e., equipment labels have been assigned in DBS, and
equipment labels and domain have been set in the transceivers/bedsides). The
transceivers and monitors should associate with APs in the system and begin to
pass data to the central station displays.
3-50