AT&T SB67010 PSTN Installation Manual page 35

Synapse Installation Guide
To connect the PSTN Gateway telephone lines:
1. Remove the plastic covers from the Gateway PSTN (telephone) jacks to be used,
marked LINE 1 through LINE 4 and BYPASS, as shown in Figure 16.
PSTN Line LEDs
If your service provider uses Centrex lines, you must use the WebUI to enter a
line access code to allow calibration to take place. Before connecting the PSTN
lines, see
2. Plug up to four telephone lines from the telephone wall jacks into the Gateway. The
line LEDs blink for up to 15 seconds during initialization.
For customer service or product information, visit our website at
www.telephones.att.com/smb
dial
Installation
LINE 1 through LINE 4
LINE 1
LINE 2
LINE 3
LINE 4
POWER
UP DOWN SELECT CANCEL
Figure 16. PSTN Gateway Telephone Line Connections
"Line Configuration" on page
If you subscribe to Digital Subscriber Line (DSL) high-speed Internet service
through your telephone line, you must plug each telephone line with DSL
service into a DSL filter. Then plug the DSL filter into the telephone wall jack,
as identified in Figure 17.
Figure 17. DSL Connection
1 (888) 883-2474
LINE 1 LINE 2 LINE 3 LINE 4 BYPASS
RESET
88.
1 (888) 916-2007
or call
.
34
Back to Contents
BYPASS
DC 5.1V
LAN
- +
. In Canada