Toolbox System Status Messages - Rena MACH 5 Operator's Manual

Toolbox System Status Messages

Displayed, in red, in the M Series Toolbox utility.
SYSTEM STATUS
PAPERPATH_FEED_TIME
OUT
PAPERPATH_PRINTZONE
_BLOCKED
Paperpath: Entry:Yes Exit:Yes
or
Paperpath: Entry: No Exit:Yes
or
Paperpath: Entry:Yes Exit:No
No = not blocked
Yes = blocked (interrupted)
DOOROPEN_FRONT
DATA_PATH_UNDERRUN
X_INK_LOW
Example: CYAN_ INK_LOW
INK_OUT_X
Example: INK_OUT_MAGENTA
CARTRIDGE_MISSING_X
or
INK_TANK_MISSING_X
Tip: When viewing the Toolbox utility; the right-most "Ink level" graphic represents the black (K) ink
tank, which is physically located in the slot closest to the operator side of the printer. The printer will not
print if any of the five ink tanks are empty or missing.
PROBLEM
Out of Paper
No media is reaching the
print engine.
Paper Jam
Media jam detected.
Printer has detected that
one of the media sensors
is blocked (interrupted).
Printer has detected that
the top section of the
print engine is open.
Printer was paused by
the user pressing the
PAUSE button.
X = Color.
One or more Ink Tanks
are low on ink.
X = Color.
One or more Ink Tanks
are out of ink
Missing Ink Tank, or Ink
Tank not being
recognized
TROUBLESHOOTING
SOLUTION
Load media into printer and press the
PAPER/RESUME button.
If media is present; check/adjust the
guides and separators.
Carefully remove jammed Media from
printer and close the print engine. The
System Status message in
away.
The toolbox "Paperpath" line should
change to:
Paperpath: Entry: No Exit: No
After you clear the jam you can;
Press RESUME button to continue
printing.
Press the CANCEL button to cancel the
job, and then manually clear the job
from the computer's print queue.
Verify that the print engine is closed
and securely latched at both sides.
Press the RESUME button to continue
printing.
Press the CANCEL button to cancel the
job, and then manually clear the job
from the computer's print queue.
Ink Tank replacement will be necessary
soon. Reorder Ink
Replace empty Ink Tank(s)
Verify that Ink Tanks are seated firmly
and latches are fully closed.
Clear error by cycling print engine
power, using ON/OFF button.
X = Color (CYMKK)
Insert missing Ink Tank or pop tank in
and out to improve connection.
Clear error by cycling print engine
power, using ON/OFF button.
SECTION 5
red should go
65