Rena MACH 5 Operator's Manual page 75

10. Remove all five Ink Tanks. Be careful to avoid spills or stains during this process. Wrap each ink
tank in a clean, lint-free, absorbent material and place them in a sealed plastic bag as a precaution
against any spillages during transport.
11. Place paper towels into each Ink Tank slot, making sure the towels make contact with the back of
the slots. This is done to absorb any ink that may leak from septum needles.
NOTE: Even though the system is deprimed, some ink will remain in the lower areas of the
tubing. In transit, this residual ink may drain out.
12. If re-boxing for transport; remove all accessories (side guides, rear media support guide) from unit
before re-boxing.
13. Re-package the printer in the original packaging material, keeping the printer level at all times.
WARNING! To help avoid damage in transit; the printer should only be shipped in approved
factory packaging. See "Unpacking" section for help with re-boxing.
Follow the sequence in reverse.
14. Ensure transport labels on the exterior box clearly indicate that the box is to be kept level at all
times.
CAUTION! The printer should remain level at all times during transportation and storage. Failure
to do so may cause the printer to leak ink. For environmental requirements during storage and
shipping, refer to the details found in the
15. When re-installing the printer at the new location, please refer to
"Transport Inspection" section.
Section 2
APPENDIX C
of this guide.
71