Rena MACH 5 Operator's Manual page 28

SECTION 2
INSTALLING THE PRINTER
6. Prepare the printhead cartridge.
Carefully remove the Printhead Cartridge from the
foil vacuum packaging. Tear at notch or cut end with
scissors.
CAUTION: DO NOT touch the ink couplings,
printhead nozzle surface or electrical contacts.
[A] Remove the protective plastic cover. Hold the
Printhead cartridge by the handle.
Unclip the ink port covers [1, 2], then unclip the cover
from the center point of the cartridge [3].
Grasp the protective cover firmly, then rotate the top of
the cartridge away from the ink port side of the cover
and lift at the same time.
Save this protective cover for future use.
CAUTION: DO NOT touch the ink couplings,
printhead nozzle surface or electrical contacts.
[B] Remove protective strip from the Printhead
Electrical Contacts.
Dispose of the removed strip immediately.
CAUTION: DO NOT allow removed strip to touch the
electrical contacts. DO NOT try to re-apply the removed
strip.
[C] Remove protective strip from the Printhead
Nozzles. Hold the Printhead by the handle with one
hand. With the other hand; grasp the strip tab and slowly
peel the strip, at an angle (90° to 45°), from the
printhead nozzles.
DO NOT pull the strip off at an angle less than 45° with
the printhead surface.
Dispose of the removed strip immediately.
CAUTION: DO NOT allow removed strip to touch the
electrical contacts or printhead nozzles. DO NOT try to
re-apply the removed strip.
NOTE: Keep packaging to store/dispose of printhead cartridge.
24