Section 2 - Installing The Printer; Transport Inspection; Tools Needed; Choosing The Location - Rena MACH 5 Operator's Manual

SECTION 2
INSTALLING THE PRINTER
Section 2 – Installing the Printer
Before using the RENA Mach 5 printer the following must be done:
•
Upon delivery; inspect packaging and report any issues to Carrier.
•
Choose a location for the printer
•
Unpack and assemble the printer
•
Install the Service Station (to be done by a qualified technician)
•
Install the Printer Software (Drivers and Toolbox)
•
Install the Ink Tanks
•
Install the Printhead
•
Set up the feed on the printer to accommodate your media (covered in

Transport Inspection

The printer is shipped in appropriate packaging so that, under normal shipping conditions, it reaches its
destination without damage.
NOTICE: Report damage to the carrier. The carrier is liable for any damage during transport.
Transport and storage should take place under the following conditions:
- At temperatures between -25°C and +50°C (-13 °F to 122 °F).
- At a relative air humidity between 5% and 95%, non-condensing.
- At an atmospheric pressure between 70 kPa and 105 kPa.
Exposure to conditions that are not permissible may lead to damage which is not externally visible.
IMPORTANT Please save the packaging materials for future use! It will be required if you ever need to
ship the printer. Before shipping; please refer to the appendix section

Tools Needed

•
Knife and scissors to open packaging
•
#2 Philips head Screwdriver
•
Carpenters Level (recommend using 18" or longer level)
•
Protective gloves should be worn to avoid getting ink on hands when removing protective
packaging materials from the ink coupling areas, the Ink Tank areas, and when
installing/removing Printhead Cartridge and Ink Tanks.

Choosing the Location

The RENA Mach 5 should be placed on a sturdy, level, worktable or cabinet at least 9 inches from any
walls. Protect the Mach 5 from excessive heat, dust, and moisture – avoid placing it in direct sunlight.

Work-Table Surface Must be Level

The surface that the printer is placed upon must be level, front to back and side to side. Use a
carpenter's level to verify that the surface is level. If the surface is not level the printer will not perform
properly. Do NOT move the printer while the power is on.
Operation should take place under the following conditions:
- At temperatures between +15°C and +35°C (-59 °F to 95 °F).
- At a relative air humidity between 20% and 80%, non-condensing.
- At an atmospheric pressure between 70 kPa and 105 kPa.
Exposure to conditions that are not permissible may lead to damage which is not externally visible.
Allow the printer, printhead and ink tanks to acclimate to ambient temperature before using the printer
6
Operating the Printer).
"Preparing the Printer for Transport".