Rena MACH 5 Operator's Manual page 30

SECTION 2
INSTALLING THE PRINTER
11. Watch the Toolbox screen on your computer
again. Notice that some of the information is in
red. As the printer circulates ink and primes the
system these fields should all turn black. This
may take a few minutes.
TIP: If the Printhead Cartridge fails to prime (ink
doesn't flow from all five color tubes at the non-
operator side of the cartridge); the printhead
cartridge will need to be removed, the nozzle
surface re-wetted, and the cartridge reinstalled.
For instruction on removing the printhead
cartridge; please refer to the section titled
"Replacing the Printhead
NOTE: If any Ink Tank is less than 30% full, the
Printhead Cartridge priming process may fail (not
enough ink to completely fill the system). In this case you will need to replace the tank(s)
containing low ink. Then re-wet the nozzles and repeat the priming process. After the Printhead is
primed, you can re-install the original Ink Tank(s) to use up any remaining ink. Please refer to the
section titled "Replacing the Ink
12. When the printer stops processing, and all the fields in System Status are black, the printer is ready
for use. When the printer is ready for use you will also observe the following printer Control Panel
condition: ON/OFF button light ON, Paper/Resume light OFF, Pause/Cancel light OFF.
NOTE: When all new Ink Tanks and a new Printhead Cartridge are installed in the system; the
printer may take up to 12 minutes to set itself up during initial startup. This is normal. The
machine will emit a number of chirps, whirrs and other noises as it circulates ink and runs
systems.
13. Close the top cover.
14. IMPORTANT! Whenever a printhead cartridge is installed or re-installed, it must be conditioned
to perform properly. Before printing a live print-job; please refer to the section titled
Cartridge Conditioning".
26
Cartridge".
Tanks".
"Printhead