Using The M Series Toolbox Utility - Rena MACH 5 Operator's Manual

SECTION 3
OPERATING THE PRINTER

Using the M Series Toolbox Utility

Once the M Series Driver and Software is installed you will have access to the "M Series Toolbox". This
Toolbox utility lets you monitor ink usage, perform diagnostic checks, print reports and run maintenance
tasks on the printer from your computer.
IMPORTANT: The printer must be powered on and connected to the computer via the USB cable, for the
Toolbox to communicate with the printer's EWS (Embedded Web Server) . If the Toolbox utility is unable
to communication with the printer; please close the Toolbox window, make sure the print engine is
powered-up (ON/OFF button lit) and then reopen the Toolbox utility.
To open the Toolbox:
Click Start from the Windows taskbar, go to
All Programs, open the "Memjet" folder, select
the "M Series Driver" folder, and then click on
"Toolbox".
When the Toolbox utility opens you will find a
series of options you can click, on at the lower
left of the screen.
NOTE: The Toolbox utility uses your web
browser to communicate with the printer's
EWS (Embedded Web Server). If you receive
warning that Windows Firewall has blocked
some features of this program. Please select
Private Networks and then click on Allow
Access.
Tip: If you receive a "Printer not responding"
message in your browser; check to be sure the
printer is turned on and the USB cable is connected. Then click on Retry.
38