Procedure (Installing The Ink Tanks) - Rena MACH 5 Operator's Manual

SECTION 2
INSTALLING THE PRINTER

PROCEDURE (Installing the Ink Tanks):

This procedure assumes that you are installing Ink Tanks into a printer that doesn't have any Ink Tanks
installed. If you are replacing an empty Ink Tank, please refer to the
1. Plug in the printer. Turn the printer's Main Power Switch ON; then press the control panel's
ON/OFF button. Wait about 45 seconds for the print engine to power-up (ON/OFF button will
illuminate).
2. Open the M Series Toolbox. Go to All Programs,
select the "Memjet" folder, select the "M Series
Driver" folder and Open the "Toolbox".
A web browser will open and display the "Printer User
Control" screen. On the left side of the screen you will
see information about the System Status and Ink
levels. With no Ink Tanks installed all Ink status levels
will all be displayed with a question mark (?) below
each color position.
Tip: If you receive a "Printer not responding" message
in your browser; check to be sure the printer is turned
on and the USB cable is connected. Then click on
Retry.
NOTE: If you receive warning that Windows Firewall
has blocked some features of this program. Please
select Private Networks and then click on Allow Access.
3. Turn the printer OFF with the ON/OFF
Button. Wait about 45 seconds for the
print engine to shut-down (ON/OFF
button light will turn off).
Note: You may loose communication with
the "M Series Toolbox" at this time.
4. Open the Ink Tank Door (hinged at
bottom). Unlock and Open the three Ink
Tank Securing Latches [A].
5. Remove the new Ink Tanks from their
packaging.
6. Slide the new Ink Tanks (label side up) into their appropriate color slots.
CYAN (C)
20
"Replacing the Ink
YELLOW (Y) MAGENTA (M)
BLACK (K) x 2
Tanks" section.