Rena MACH 5 Operator's Manual page 25

INSTALLATION TIP – To make sure the Ink Tank seats properly (septum needles penetrate the
seals on the tank and the tank contacts make a good electrical connection with the system): Insert
the Ink Tank firmly. Then pull the Ink Tank back out about an inch. Then push the Ink Tank back
in, firmly.
7. Close and lock all three Ink Tank Securing Latches.
IMPORTANT: Make sure both sides of the Latch are engaged at the bottom.
8. Turn the printer's Main Power Switch ON; then press the control panel's ON/OFF button. Wait
about 45 seconds for the print engine to power on (ON/OFF button will illuminate).
9. Refresh your web browser window. Watch the
Toolbox screen on your computer; you will see the
ink colors fill in as the Ink Tanks are recognized.
Tip: If the Toolbox utility does not respond; verify
that the printer is powered on and that the USB
cable is connected. Then try closing and opening the
Toolbox utility again.
Tip: If an ink color does not fill in after a few
minutes; reseat the Ink Tank by popping it in and
out; as described in Step 6 "Installation Tip".
Power-down the print engine using the ON/OFF
button. Then repeat from Step 8.
10. Close the Ink Tank Door.
11. Close the Top Cover.
12. If a Printhead Cartridge is not installed the Systems Status line in the Toolbox will display
"MISSING PRINTHEAD message. To install the Printhead Cartridge; please proceed to the
section titled "Installing the Printhead Cartridge".
SECTION 2
INSTALLING THE PRINTER
21