Rena MACH 5 Operator's Manual page 33

Printer Status Light Indicator Chart (see legend on previous page)
PAPER PAUSE
ON/OFF
RESUME CANCEL
/ / / /
/
/
/ fast
Please see the "Toolbox System Status
Printer Status
Feeding
corresponding Toolbox message
No Print engine is powered-OFF
No Print engine is powered-ON and ready
/ /
No Print engine powering-down
/
No Job loading, processing
/ No Busy: Cleaning, circulating ink, etc..
Yes Printing
Paper time-out (out of paper), other Errors
/
No
Toolbox =
PAPERPATH_FEED_TIMEOUT
Tilt Error
No
Toolbox =
Ink Tank(s) Empty
No
Toolbox =
Messages" section for more details on Toolbox messages
Possible Solution
In this condition, it is safe to turn the Main Power Switch OFF or ON.
Printer is Ready
Wait until all lights go out before turning OFF the Main Power Switch.
Wait
Wait
Press PAUSE, to pause printing.
Press RESUME, to resume printing.
Press the CANCEL button to clear the error or cancel a paused job. If
job was canceled; manually clear job from the computer's print queue.
Errors can also be cleared using Toolbox Interface.
Verify that table is level (front to back and left to right).
If just powered on, wait a few minutes; tilt readings may settle
into normal range. Then error can be cleared using CANCEL
button or by using the "Clear Error" feature in the Toolbox.
TILT_ERROR
Contact technical support person to have them, check level
and possibly use Toolbox "Printer Maint Config" feature
(located under Service Menu) to Zero Tilt Sensor.
If problem persists they can temporarily disable tilt sensor
using "Printing Control Config" features in Service Menus.
Replaced empty Ink Tank(s).
Verify that Ink Tanks are seated firmly and latches are fully closed.
INK_OUT_...
Clear error by cycling print engine power, using ON/OFF button.
SECTION 3
OPERATING THE PRINTER
.
29