Rena MACH 5 Operator's Manual page 36

SECTION 3
OPERATING THE PRINTER
3. Loosen the locking screws, located behind
the sheet separators, and raise the
separators. Then tighten the locking screws
to hold the separators in the up position.
4. Place a single piece of the media, to be run,
under the separators. Always place the
media against the Media Registration Side
Guide.
5. Loosen the separator locking screw and
allow the separator to settle onto the media.
Then tighten the locking screw. Repeat for
each sheet separator.
IMPORTANT
Be sure that unused separators are
locked in their raised position. If not,
they will rub on the feed rollers, causing
transport problems and damage to the
rollers and separators.
6. Loosen the locking knob and reposition the Adjustable
Media Side Guide so that it is about 1/32-inch from the
side of the media. Tighten the locking knob on the side
guide.
Tip: If the right edge of the media is damaged, during
transport through the print engine; try repositioning both of
the media side guides so the Adjustable Media Side Guide is
no less than 1/8" away from the side frame.
32