User Interface - Rena MACH 5 Operator's Manual

SECTION 3
OPERATING THE PRINTER

User Interface

The User Interface (Printer User Control)
window opens by default when you start the
Toolbox utility.
From this screen you can Clear Errors,
Cancel a Job, Reset the Job Counter, and
Reset the Page Counter. You can also
perform some maintenance and operating
tasks such as:
Clear Error – Clears some printer errors
that are displayed in the Toolbox.
Cancel Job – Clears the current job from the
print engine. Job must be manually cleared
from computer's print queue.
Reset Job Counter – Resets the job count.
Reset Page Counter – Resets the page
count.
Wipe Printhead – Service Station's wiper roller is used to wipe/clean the printhead.
Circulate Ink – Can be used to help purge air from the printhead and ink system.
Caution! Don't run this feature more than two times in a row. Doing so can build-up too much pressure in
the system which may cause excessive ink waste and ink spills to occur.
Release Printhead – Use this feature to prepare the printer for the installation or removal of the Printhead
Cartridge. This feature pumps some of the ink back into the Ink Tanks and then it releases (opens) the
Printhead Latch. Same as using the Printhead Latch Release Button.
See "Installing Printhead Cartridge" or "Replacing Printhead Cartridge" for more details
System Deprime – Use this feature to prepare the printer for service or transport to a remote location. This
feature pumps most of the ink back into the Ink Tanks and then releases (opens) the Printhead Latch.
See Appendix "Preparing the Printer for Transport" for more details.
Eject Service Station – Ejects the Service Station from the printer. This feature should only be used by a
qualified technician during maintenance.
Install Service Station – Pulls the Service Station into the printer. This feature should only be used by a
qualified technician during installation or maintenance.
Shutdown – Properly powers-down the print engine. After the print engine powers-down, all control panel
lights will turn off. It is now safe to turn off the printer using the Main Power switch.
Media Profile Upload – Use to upload new color profiles for different types of media.
Firmware Download – Use to update the printer's firmware.
39