Inspecting/Replacing The Ink Waste Tray - Rena MACH 5 Operator's Manual

SECTION 4
MAINTENANCE

Inspecting/Replacing the Ink Waste Tray

The Ink Waste Tray is filled with an absorbent material, used to capture any ink that should drain from the
system.
1. If the printer is on; press the ON/OFF button to power-down the print engine. Wait about 45
seconds until the system shuts down (all control panel lights will go off).
Turn off the Main Power Switch and unplug the printer from the power receptacle.
WARNING! If this power-down process is not followed; ink color mixing and printhead nozzle
clogging may result.
2. Unplug the power cable from the printer.
3. Open the Ink Tank door
4. The Ink Waste Tray is secured to the print engine frame by two tabs.
One tab is located at the left side of the tray and one at the right side.
Simultaneously push the two tabs in towards the tray, while pulling the tabs out towards you. The
Ink Waste Tray should release from the frame and begin sliding towards you.
5. Slide the Ink Waste Tray out from under the print engine.
6. If the absorbent material (123-10005, Waste Ink Absorber) is saturated with ink, please order and
replace this item.
7. When re-installing the Ink Waste Tray, push the tray in evenly and slide it all the way back until it
stops. Make sure the tray securing tabs snap into the print engine frame.
58