Section 3 - Operating The Printer; Control Panel Functions - Rena MACH 5 Operator's Manual

Section 3 – Operating the Printer

Control Panel Functions

BUTTON FUNCTION(s)
Press to power-up or power-down the print engine.
Note: The Main Power Switch must be ON, to power-up the print engine.
Powering-up: It takes approximately 45 seconds for the print engine to power-up;
after pressing this button. The ON/OFF button will illuminate when the print
engine is powered-up.
ON/OFF
Powering-down: Before turning off the printer, using the Main Power Switch;
please be sure to power-down the print engine using this button. When the print
engine has completed its power-down cycle, all lights in the control panel will turn
off. It is now safe to turn off the Main Power Switch.
WARNING! If this power-down process is not followed; ink color mixing and
printhead nozzle clogging may result.
PAPER (Paper Feed Test): Before sending data to the printer; you can perform a
paper feed test by pressing and holding this button for 4 seconds. The printer will
feed a single page.
PAPER/RESUME
RESUME: If an "out of paper" condition is detected; reload media and press this
button to resume printing.
If the printer was paused using the PAUSE/CANCEL button, press this button to
resume printing.
PAUSE: If you are in the process of printing and you want to pause the print job,
press this button once.
If the printer was paused, using the PAUSE/CANCEL button, press the RESUME
button to resume printing.
PAUSE/CANCEL
CANCEL: If you want to cancel a paused print job, press this button again. The
print job will be cleared from the printer. You must manually clear job from
computer's print queue.
Please see "Printer Status Light Indicators", for additional information.
SECTION 3
OPERATING THE PRINTER
27