Section 2 - Installing The Printer; Transport Inspection; Tools Needed - Rena MACH 5 Operation Manual

Section 2 – Installing the Printer
Before using the Digital Color Printer the following must be done:
•
Transport Inspection. Upon delivery; inspect packaging and report any issues to the Carrier
•
Gather Tools.
•
Choose a location for the Printer
•
Unpack and verify Accessory Box contents
•
Attach the Media Guides to the Printer
•
Remove the Service Station Transport Tab and Shipping Tape
•
Plug in the Printer and Connect it to the Computer
•
Install the Printer Software (Driver & Toolbox)
•
Install the Ink Tanks
•
Install the Printhead
•
Install the PPS spacers (if needed)

Transport Inspection

The printer is shipped in appropriate packaging so that, under normal shipping conditions, it reaches its
destination without damage.
NOTICE: Report damage to the carrier. The carrier is liable for any damage during transport.
Transport and storage should take place under the following conditions:
- At temperatures between -25°C and +50°C (-13 °F to 122 °F).
- At a relative air humidity between 5% and 95%, non-condensing.
- At an atmospheric pressure between 70 kPa and 105 kPa.
Exposure to conditions that are not permissible may lead to damage which is not externally visible.
IMPORTANT Please save the packaging materials for future use! It will be required if you ever need to
ship the printer. Before shipping; please refer to the section titled "Preparing the Printer for Transport".

Tools Needed

•
Knife and scissors to open packaging
•
Carpenters Level (recommend using 18" or longer level)
•
Protective, nitrile powder-free gloves should be worn to avoid getting ink on hands when
removing protective packaging materials from the ink coupling areas, the Ink Tank areas, and
when installing/removing Printhead Cartridge and Ink Tanks.
•
Distilled or de-ionized water
•
Non-abrasive, lint free cloths
SECTION 2
INSTALLING THE PRINTER
5