Zone Wiring - Texecom Premier 640 Installation Manual

Programming the Control Panel

Zone Wiring

Zone wiring connections are shown on page 21 the following
programming options are available.
0 - Normally Closed
For use on normally closed devices without tamper
protection. Normally used for keyswitches. See Normaly
Closed wiring diagram on page 21
1 - Normally Open
For use on normally closed devices without tamper
protection. Normally used for keyswitches. See Normaly
Open wiring diagram on page 21
2 - Double Pole/EOL
Default zone wiring configuration as shown on page 21
3 - Triple EOL
Standard Texecom TEOL as illustrated on page 21, use this
wiring type for all Texecom anti masking detectors.
4 - 1K/1K/(3K)
Alternative TEOL configuration with 1K alarm resistor, 3K fault
resistor and 1K EOL resistor
5 - 4K7/6k8/(12K)
Alternative TEOL configuration with 6K8 alarm resistor, 12K
fault resistor and 4K7 EOL resistor.
6 - 2K2/4K7/(6k8)
Alternative TEOL configuration with 4K7 alarm resistor, 6K8
fault resistor and 2K2 EOL resistor
7 - 4K7/4k7
Alternative EOL configuration with 4K7 alarm resistor and 4K7
EOL resistor.
8 - WD Monitor
Specialised wiring configuration for monitoring warning
devices with fault reporting capability. Only use this wiring
type on zones types programmed as Auxilliary. Normally
wired as a Normally Closed circuit.
DD 243
To comply with DD 243, during the normal entry delay, the
control panel must prevent a Confirmed Intruder Alarm from
being reported to the Alarm Receiving Centre.
WARNING
Owing to the ability to disable ALL of the
confirmation facilities, the customer should be
advised in writing by the alarm company that ALL
means of alarm confirmation are disabled when the
initial entry door is opened. The alarm company
should then obtain written acceptance from the
customer of the disabling of the means of alarm
confirmation.
38
Premier 640 Installation Manual
INS344