Warning/Error Messages; Errors Detected In The Camera Module; Errors Detected In The Vtr Module - Sony SRW-9000 Operation Manual

Warning/Error Messages

Errors Detected in the Camera Module

If low battery power is detected, or if an error or other abnormal condition occurs on power on or during
operation, the RUN indicator flashes and alarm message flash in the viewfinder, on the external monitor,
and in the subdisplay.
Viewfinder screen
Basic status Message
display (see
page 57)
BATT flashes
BATT flashes
TEMPERATURE
CARE
TEMP WARNING/
FAN MAX
SHUTDOWN
CAMERA/FAN MAX
OHB FAN NG!
MAIN FAN NG!
CAM? OHB NG!
CAM? AD BOARD NG!
CAM? VDA BOARD NG!
CAM? VPR BOARD NG!
VTR ALARM
VTR WARNING
Errors Detected in the VTR
Module
When the unit stops operating correctly because
of an internal error, a warning tone sounds and a
popup window appears on the display of the
control panel with an error message.
Only one message is displayed at one time, even
if multiple errors occur. But the number of current
Subdisplay RUN indicator
BATT flashes Flashes
BATT quickly Flashes quickly
errors appears at the bottom of the popup
window.
At the same time, a VTR module error message
appears in the viewfinder and in the message
display section of the monitor screen.
Meaning
Power voltage is low (has
reached the specified NEAR
END value).
Power voltage is exhausted
(has reached the specified END
value).
The temperature inside the unit
is high.
The temperature inside the unit
has risen to the limit. FAN
MODE has been forcibly set to
MAX.
The unit must be powered off
for safety. FAN MODE has
been forcibly set to MAX.
The fan near the CCD has
stopped.
The fan in the main unit has
stopped.
CCD unit error
AD board error
VDA board error
VPR board error
Alarm in the VTR module
Warning in the VTR module
Warning/Error Messages 157